Post by vividjazz on Jan 28, 2006 14:26:45 GMT 10
Head unit removal or installation.
* Remove Inner glove box
* Remove the screw (A). Detach the clips (B) and release the hooks (C) by pulling the center lower cover (D) down, by hand.
* Disconnect the heater control unit connectors (D), and release the unit harness (E) from the clamp.
* In the inner glove box opening, disconnect the recirculation control cable and the mode control cable (B), and from under the dashboard, disconnect the air mix control cable (C):
* Take care not to bend any cables.
* LHD is shown, RHD is symmetrical.
* From the glove box and driver's dashboard lower cover openings, loosen the bolts securing the center panel (A).
* Using a wrench, carefully insert a wrench from the inner glove box opening, and push a panel clip on the glove box side from back of the center panel (A) to release it. LHD is shown, RHD is symmetrical.
* Pull out the center panel (A) to release the clips (B, C), and disconnect the heater control switch connector (D), antenna lead (E), rear deffoger switch connector (F) and if equipped, navigation unit connectors (G) and GPS antenna connector (H). Detach the harness clips(I) from both center panel brackets. Then remove the center panel:
* Take care not to bend any cables.
* LHD with navigation is shown, RHD is symmetrical for the most part, and if equipped with no navigation, disconnect the audio unit connector.
* Remove the seven mounting screws, then remove the audio unit (A).
* Remove the four mounting screws from the LCD unit (A), then remove the cover (B).
* Remove the two knobs (A).
* Remove the sixteen mounting screw from the printed circuit board (B), then remove the printed circuit board and LCD unit.
* Remove Inner glove box
* Remove the screw (A). Detach the clips (B) and release the hooks (C) by pulling the center lower cover (D) down, by hand.
* Disconnect the heater control unit connectors (D), and release the unit harness (E) from the clamp.
* In the inner glove box opening, disconnect the recirculation control cable and the mode control cable (B), and from under the dashboard, disconnect the air mix control cable (C):
* Take care not to bend any cables.
* LHD is shown, RHD is symmetrical.
* From the glove box and driver's dashboard lower cover openings, loosen the bolts securing the center panel (A).
* Using a wrench, carefully insert a wrench from the inner glove box opening, and push a panel clip on the glove box side from back of the center panel (A) to release it. LHD is shown, RHD is symmetrical.
* Pull out the center panel (A) to release the clips (B, C), and disconnect the heater control switch connector (D), antenna lead (E), rear deffoger switch connector (F) and if equipped, navigation unit connectors (G) and GPS antenna connector (H). Detach the harness clips(I) from both center panel brackets. Then remove the center panel:
* Take care not to bend any cables.
* LHD with navigation is shown, RHD is symmetrical for the most part, and if equipped with no navigation, disconnect the audio unit connector.
* Remove the seven mounting screws, then remove the audio unit (A).
* Remove the four mounting screws from the LCD unit (A), then remove the cover (B).
* Remove the two knobs (A).
* Remove the sixteen mounting screw from the printed circuit board (B), then remove the printed circuit board and LCD unit.
